JennAir PRESS CLEAN BUTTON: the milk frother needs its rinse
After cappuccino or latte, the JennAir asks you to rinse the milk path.
Mon–Sat, 8am–8pm
- Milk system
- Coffee machine milk system repair
- Source: JennAir
Book a visit
Three short steps, about a minute.
or call (844) 551-4777
Loading appointment form…
The appointment form couldn’t load. Please try again.
What PRESS CLEAN BUTTON
actually means.
After cappuccino or latte, the JennAir asks you to rinse the milk path. The Clean button on the milk container lid has to be held for at least 8 seconds, and the rinse stops the moment it is let go. After the rinse, the container goes back in the refrigerator, since JennAir allows milk out for no more than 15 minutes.
JennAir coffee machine display
What to do when PRESS CLEAN BUTTON shows on the coffee machineKind of codeMilk system
The milk system could not draw, heat or foam the milk as it should: a tube pinched or not pushed fully onto its connector, a frother or valve clogged with dried milk, a skipped cleaning cycle, or a steam valve and seal that no longer hold. Taking the milk parts apart for a rinse where the manual allows, and running the milk cleaning cycle, clears most of it; steam hissing from the wrong place or a frother that stays cold is a visit.
Usually leads toCoffee machine milk system repair
Restoring the froth: the milk tube, the frother, the air inlet, the milk valve and the cleaning cycle that keeps them clear.
Shows up asWhat a Coffee Machine Error Code or Warning Symbol Means
A coffee machine error code may show as a short string of letters and numbers, a flashing symbol for water, grounds or the brew unit, a short sentence on a text display, or a machine that stops with one light blinking.
MakeJennAir
A JennAir built-in coffee maker that has gone quiet or started dripping is checked in the kitchen, beginning with the tray sensor and the tank contacts.
SourceJennAir help: cleaning the milk frother
JennAir 24-inch built-in coffee systems: JJB6424HL (Rise), JJB6424HM (Noir) and the earlier Euro-Style JBC7624BS.
Before you book,
in this order.
Each step comes from JennAir's own guidance for PRESS CLEAN BUTTON on its coffee machines. Follow it to the end: the last card says whether this is a visit.
Place a container under the milk spout.
Press and hold CLEAN on the milk container lid for at least 8 seconds and keep holding until the progress bar completes.
Remove the milk container, push the spout down against it and put it back in the refrigerator.
If the message will not clear after a full rinse, book a visit.
Still there?
It usually turns into coffee machine milk system repair. Book with the code and the model number.
What not to do
PRESS CLEAN BUTTON does not mean the frother is blocked. It is also not a descale reminder, which reads DESCALE!.
What you may
notice with it.
The coffee machine problems PRESS CLEAN BUTTON tends to arrive with. Answer these at the coffee machine before anyone is booked.
All problems
Where PRESS CLEAN BUTTON usually leads
Coffee machine milk system repair.
JennAir
coffee machines.
A JennAir built-in coffee maker that has gone quiet or started dripping is checked in the kitchen, beginning with the tray sensor and the tank contacts.
JennAir coffee machine repairMore JennAir codes
Milk system on other makes
In JennAir's own words
Press and hold CLEAN on the milk container lid for at least 8 seconds.
Every code on this site is taken from the manufacturer's documentation, never from a forum or a parts listing. JennAir 24-inch built-in coffee systems: JJB6424HL (Rise), JJB6424HM (Noir) and the earlier Euro-Style JBC7624BS.
JennAir PRESS CLEAN BUTTON coffee machine repair,
where we come out.
The same visit in every metro below: the code, the model number, and a diagnosis before any part is ordered.
All service areasTampa BayFL · 31 areas
Miami / South FloridaFL · 47 areas
New York MetroNY · 75 areas
HoustonTX · 36 areas
ChicagoIL · 50 areas
Los AngelesCA · 95 areas
San DiegoCA · 31 areas
Questions
about PRESS CLEAN BUTTON.
Can I clear PRESS CLEAN BUTTON myself?
Why did the JennAir milk rinse stop halfway?
How long can I leave milk out in the JennAir container?
Do I still need to wash the JennAir milk container if I run the rinse?
Back to your everyday
Still showing PRESS CLEAN BUTTON?
Three things make the booking useful: the message or number exactly as the display showed it, the full model number from the plate, and whether the machine still grinds and pours at all. Send those and the likely part can be looked up before the van leaves.