Miele F73: the brew unit cannot reach its position
The brew unit has to travel to a set position and compress the grounds before water goes through.
Mon–Sat, 8am–8pm
- Brew unit
- Coffee machine brew unit repair
- Source: Miele
Book a visit
Three short steps, about a minute.
or call (844) 551-4777
Loading appointment form…
The appointment form couldn’t load. Please try again.
What F73
actually means.
The brew unit has to travel to a set position and compress the grounds before water goes through. When it cannot get there, either because it is dirty or because its drive is out of step, the machine stops and shows F73. Miele's fix is to rinse the unit, set its coffee ejector, and let the machine reset the motor with the unit out.
Miele coffee machine display · also shown as Check the brew unit
What to do when F73 shows on the coffee machineKind of codeBrew unit
The brew unit did not reach the position the control expected, or could not press and brew as it should: it is caked with old grounds, dry where it needs its grease, jammed by a dose too large, or its drive and seals are worn. On a machine with a removable unit, lifting it out with the power off and rinsing it is the owner's check; a fixed unit is cleaned by its own cycle, and anything past that is a visit.
Usually leads toCoffee machine brew unit repair
Resealing, lubricating or replacing the brew unit that tamps the grounds and presses water through them, removable or fixed.
Shows up asWhat a Coffee Machine Error Code or Warning Symbol Means
A coffee machine error code may show as a short string of letters and numbers, a flashing symbol for water, grounds or the brew unit, a short sentence on a text display, or a machine that stops with one light blinking.
MakeMiele
Miele coffee systems are serviced at home, with the brew unit lifted out and inspected once the machine has cooled.
SourceMiele CVA 7440 built-in coffee system operating and installation instructions (en-US, CA)
Miele CVA 7440 built-in coffee system (tank-fed, M.-Nr. 12 867 300). Miele shows F73 or the words Check the brew unit for the same condition.
Before you book,
in this order.
Each step comes from Miele's own guidance for F73 on its coffee machines. Follow it to the end: the last card says whether this is a visit.
Switch the machine off and let it cool, then open the door and try to lift out the brew unit; if it comes out, rinse it under running water.
Push the unit's coffee ejector back into its correct position, refit the water container, close the door and switch on with the brew unit left out so the motor returns to its start position.
When Insert the brew unit appears, put it back and close the door; if the unit will not come out at all, switch off for about 2 minutes and try again, and book a visit if it stays stuck.
Still there?
It usually turns into coffee machine brew unit repair. Book with the code and the model number.
What not to do
F73 is not a grinder problem, even though no coffee comes out. It is also not solved by forcing the brew unit in or out, which can damage its drive.
What you may
notice with it.
The coffee machine problems F73 tends to arrive with. Answer these at the coffee machine before anyone is booked.
All problems
Where F73 usually leads
Coffee machine brew unit repair.
Miele
coffee machines.
Miele coffee systems are serviced at home, with the brew unit lifted out and inspected once the machine has cooled.
Miele coffee machine repairMore Miele codes
Brew unit on other makes
Built-in coffee system
The coffee machine set flush into a tall kitchen cabinet, filled from a water tank behind its front, grinding beans and brewing each cup on its own before sliding out on rails for service.
Plumbed coffee system
The built-in coffee machine connected to the house water supply, filling itself through an inlet valve and sometimes draining its rinse water to a line of its own, so nobody ever lifts out a tank.
Countertop espresso machine
The fully automatic bean-to-cup machine that stands on the counter, grinding, tamping, brewing and frothing at the touch of a key, with its tank, hopper and grounds drawer all reached from the top and the front.
In Miele's own words
The brew unit cannot be positioned correctly or is soiled. It is not possible to press the ground coffee.
Every code on this site is taken from the manufacturer's documentation, never from a forum or a parts listing. Miele CVA 7440 built-in coffee system (tank-fed, M.-Nr. 12 867 300). Miele shows F73 or the words Check the brew unit for the same condition.
Miele F73 coffee machine repair,
where we come out.
The same visit in every metro below: the code, the model number, and a diagnosis before any part is ordered.
All service areasTampa BayFL · 31 areas
Miami / South FloridaFL · 47 areas
New York MetroNY · 75 areas
HoustonTX · 36 areas
ChicagoIL · 50 areas
Los AngelesCA · 95 areas
San DiegoCA · 31 areas
Questions
about F73.
Can I clear F73 myself?
Why does my Miele say to switch on with the brew unit left out after F73?
My Miele brew unit will not come out after F73. Should I pull harder?
Can oily beans cause F73 on a Miele coffee system?
Back to your everyday
Still showing F73?
Three things make the booking useful: the message or number exactly as the display showed it, the full model number from the plate, and whether the machine still grinds and pours at all. Send those and the likely part can be looked up before the van leaves.